Changing programme parameters
The settings for individual parameters set at the factory are outlined in the
Programme chart at the end of these operating instructions.
Programme parameters can only be changed if they are activated in a
programme; see Programme chart.
Any changes carried out must be documented, e.g. handwritten into the
corresponding column of the Programme chart.
Changing the wash parameters
The parameters for the cleaning programmes can be changed to suit particular
requirements. For this purpose, the temperature and the temperature holding time
in the Main wash 1 and 2 and Final rinse 1 and 2 programme blocks can be
changed.
The programme parameters for the Main wash 1 programme block in the
SPECIAL 93°C-10' programme cannot be changed.
Temperatures over 55°C result in blood denaturation and fixing.
On the varioTD programme, take note of the appropriate requirements for
infection prevention.
Values which can be set for the temperature:
30°C - 93°C in Programmes A to G and varioTD in 1°C increments
Values which can be set for the holding time:
1-15 mins.
Changing the drying parameters
The parameters for drying can be changed to suit particular requirements. The
temperature and drying time can both be changed in programme blocks Drying 1
(if available) and 2.
Values which can be set for the temperature:
50°C - 99°C in 1°C increments
Values which can be set for the drying time:
Drying 1: 1-99 minutes in 1 minute steps
Drying 2: 5-95 min in 5 minute steps
The drying time for programme block Drying 2 can also be altered using the 0
button (see "Operation, Selecting the additional Drying 0function").
Programmable functions
45