4.Member: Press ”Space” key to change the member value. There are two types to selected:
a. | Member: the port is a member port. |
b. | NO: it means that port is NOT a member port. |
5.Press “ESC” key to go back action menu line.
6.Select <Apply> to apply the configuration.
[Note] If you have configured the trunk groups, you can see it (ex: Trunk1, Trunk2…) in the port list. You also can configure the trunk group as the VLAN member.
Create VLAN Group: PortBase interface
Create 802.1Q VLAN
1.Enable security VLAN setting: select to enable or disable security VLAN group. When you select to enable security VLAN group, only the members in this VLAN group can access to the switch. The steps of setting security VLAN refer to the following step 2~ 8. After you configured the security VLAN group, you can continue to create other VLAN groups. When you didn’t select to configure security VLAN group, then just create VLAN group refer to following step 2 ~ 8.
[Note] There is only one security VLAN group.
76
