.A complete Parts List is available on-line at www.MillerWelds.com

6-8. Troubleshooting Table

 

 

 

 

 

 

 

 

 

 

 

Trouble

 

 

Remedy

 

 

No weld output; wire does not feed; fan

Secure power cord plug in receptacle (see Section 4-7or 4-8).

does not run.

 

 

 

Replace building line fuse or reset circuit breaker if open.

 

 

 

 

 

 

 

Place Power switch in On position (see Section 5-2, 5-1, or 5-3).

 

 

 

 

 

Reset welding power source supplementary protector if open.

 

 

No weld output; wire does not feed; fan

Thermostat TP1 open (overheating). Allow fan to run with gun trigger switch off; thermostat closes when

motor continues to run.

unit has cooled (see Section 6-3).

 

 

 

 

 

Secure gun trigger plug (see Section 4-1).

 

 

 

 

 

Release gun trigger and cycle unit power off and back on again.

 

 

No weld output; wire feeds.

Connect work clamp to get good metal to metal contact.

 

 

 

 

 

Replace contact tip (see Section 6-5).

 

 

 

 

 

Check for proper polarity connections (see Section 4-5).

 

 

 

 

 

Check thumbscrew securing gun end to feed head adapter and tighten if necessary.

 

 

Low weld output.

Connect unit to proper input voltage or check for low line voltage.

 

 

 

 

 

Place Power switch in On position (see Section 5-2, 5-1, or 5-3).

 

 

Electrode wire feeding stops during

Straighten gun cable and/or replace damaged parts.

welding.

 

 

 

Adjust drive roll pressure (see Section 4-11).

 

 

 

 

 

 

 

Change to proper drive roll groove (see Section 6-4).

 

 

 

 

 

Readjust hub tension (see Section 4-10).

 

 

 

 

 

Be sure that wire is positioned in proper drive roll groove and wire is laying in the groove.

 

 

 

 

 

Replace contact tip if blocked (see Section 6-5). Oversized tip may be required for some wires.

 

 

 

 

 

Clean or replace wire inlet guide or liner if dirty or plugged (see Section 6-4or Section 6-6).

 

 

 

 

 

Replace drive roll or pressure bearing if worn or slipping (see Section 6-4).

 

 

 

 

 

Secure gun trigger plug (see Section 4-1).

 

 

 

 

 

Check and clear any restrictions at drive assembly and liner (see Section 6-4or Section 6-6).

 

 

 

 

 

Release gun trigger and allow gun and motor protection circuitry to reset.

 

 

 

 

 

Have nearest Factory Authorized Service Agent check drive motor.

 

 

 

 

 

OM-225 311 Page 40

Page 44
Image 44
Miller Electric M-10 Gun, 180, 140 Auto-Set manual Troubleshooting Table, Trouble Remedy