SECTION 4 − INSTALLATION
4-1. Selecting A Location And Moving Polyweld System
YDisconnect input power conductors from deenergized supply BEFORE moving polyweld system.
1Lifting Eye
2Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond opposite side of unit.
3 Rating Label
Movement
1
OR
2
Use rating label to determine input power needs.
4 Line Disconnect Device
Locate unit near correct input pow- er supply.
Location And Airflow
18 in |
|
(460 mm) | 4 |
18in
(460 mm)
18 in
(460 mm)
3
18in
(460 mm)
Special installation may be required where gasoline or volatile liquids are present − see NEC Article 511 or CEC Section 20.
18 in
(460 mm)
Do not block airflow to bottom of unit.
ssb9.1 5/94 −
