Mitsubishi Electronics CS-35305 manual Procedure See illustration on the following

_ Important:

_'Important:

procedure

(See illustration on the following page.)

0Connect the incoming cable or antenna to the ANTENNA IN terminal on the VCR.

OConnect one end of a coaxial cable to the ANTENNA OUT terminal on the VCR.

Connect the other end of the coaxial cable to the antenna terminal on the TV.

O Connect an RCA pin-type video cable tc the VIDEO OUT terminal on the back of the VCR. Connect the other end of this cable to the VIDEO INPUT terminal on the back of the televi- sion.

If you are connecting a Super _rHS (S-VHS)VCR, use an S-Video cable instead of an RCA pin-type video cable. Connect this S-Video cable to the S-VIDE0 OUT terminal on the VCR. Connect the other end of this cable to the S-VIDEO INPUT terminal on the back of the TV.

OConnect a set of RCA pin-type audio cables to the AUDIO OUT

terminals on the back of the VCR. Use the red cable tc connect the right (R) channel and the white cable for connecting the left

(L)channel.

Connect the other ends of these cables r2 the AUDIO INPUT

terminals on the back of the TV.

If your VCR is monaural (non-stereo), you on:[y need to connect a single RCA pin-type audio cable. Connect t:he cable to the VCR, then connect the other end to the L (LEFT) audio input on the back of the TV.

_Important:	If your VCR has	a video	channel	switch with an "0FF/AV" position,
	set it that position. See your VCR's owner's gaide for details.
	Start playing	a tape	on your	VCR.

Use the INPUT button on :your TV's remote control to select

Input-1.

Basic Connections 29