Troubleshooting (cont.)
Problems | Possible | Solutions | For More Information |
The remote control doesn't work.
Check that the batteries are installed correctly.
Check that the select button is set to "TV."
See "Getting ready to use the remote control" in
Chapter 1 for an explanation of how to install batteries in the remote control.
See "Remote control buttons and fu_ctions" in Chapter 1, which explains where the select buttons are located.
The TV takes several
seconds to respond to button commands.
You can't access a channel.
You can't see a different
picture in l_he reduced PIP image.
Be sure that you are point- ing the tip of the remote control toward the TV from a distance of no more than
20 feet.
•Use the ENTER button to avoid delays.
Be sure that the channel you want to view is programmed into memory.
Check that the TV is tuned to the correct input source (antenna) for that channel.
•Use the SOURCE button to
select the picture from your VCR.
•Turn on your VCR and select a channel different from the one on your TV.
See "Getting ready to uae the remote control" in Chapter 1, which contains pointers for using the remote control
See "Changing channels" in Chapter 3, which explains the function of the ENTER button.
See "Memorizing channels" in Chapter 3, which explains how to program channels into the TV's memory.
See "Selecting the input source" in Chapter 3, which explains how to change the input source.
•See "Using the Advanced
80 | Chapter | 5: Troubleshooting |
