Mitsubishi Electronics Connecting a digital recorder to DX-VS1UE, Connecting BNC cable

5.Connecting a digital recorder to DX-VS1UE

1) Connecting BNC cable

Connect one end of BNC cable with the video input connector of DX-VS1UE and the other end with one of video output connector on the rear surface of digital recorder. Use 75ohm(3C-2V type or more) type cable as BNC cable.

2) Connecting RS-232C cable

Connect RS-232C connector of a digital recorder to the RS-232(1) (refer to the following image) connector of DX-VS1UE using the attached serial cable for digital recorder connection. One end of the attached serial cable consists of three wires(red,yellow,black). Connect red wire to RX1, yellow one to TX1 and black one to GND terminal. For connecting, loosen each fixing screw , insert three wires into each terminal and fasten each fixing screw.

16

DX-VS1UE User’s Manual