Mitsubishi Electronics DX-VS1 Transmission Performance of E-mail and FTP, FTP event configuration

Models: DX-VS1

1 38
Download 38 pages 14.84 Kb
Page 23
Image 23
(6) FTP event configuration

(6) FTP event configuration

Administrator can set transmission conditions, image resolution, and file name. The setting method of image resolution, filename, and transmission conditions of FTP is the same as that of e-mail.

Transmission Performance of E-mail and FTP

!DX-VS1UE can send e-mail once per five minutes at most in case administrator set DX-VS1UE to send e-mail periodically. If there were no restriction in sending e-mail, DX-VS1UE might cause a serious problem to the recipient’s mail server. However, there is no limit in e-mail transmission triggered by mo- tion detection event or sensor event.

!There is no limit.in the FTP funcion. If you set 0 to the periodic sending menu, DX-VS1UE transmits files at best performance.

!Regarding the FTP function, if the interval between two events is within 2 sec- onds, the second event may be neglected. If the second event occurs within 3 seconds after image transmission, the second image file is not transmitted at times.

!Regarding the e-mail function, if the interval between two events is within 3 sec- onds, the second image file is not transmitted at times.

7)Pan/tilt/zoom Configuration

This page is used to select the serial port for connectiing with a pan/tilt/zoom camera and to set pan/tilt/zoom functions such as ‘Mode’, ‘Preset’, etc.

(1) Select Serial Port

It is to select a serial port among Serial#2, and Serial#3 with which a Pan/tilt/zoom control receiver is connected to DX-VS1UE. Serial#2 are RS232-C interfaces and Serial#3 is RS-422/RS485 inter- face.

(2) Serial Port Base Address

This menu is used to identify the base addresses (camera ID or camera Number) between DX- VS1UE and a Pan/tilt/zoom camera. Administrator can connect pan/tilt/zoom camera through ana- logue pan/tilt/zoom controller.

When RS485 is chosen as an interface and two or more Pan/tilt/zoom cameras are connected, it is necessary to set Camera ID to each camera and to set it to the base address(Camera ID) to which DX-VS1UE corresponds.

22

DX-VS1UE User’s Manual

Page 23
Image 23
Mitsubishi Electronics DX-VS1 Transmission Performance of E-mail and FTP, FTP event configuration, Select Serial Port