Chapter 3. TV Setup | 35 |
Installing the Remote Control Batteries
1.Remove the remote control’s back cover by gently pressing in the tab and lifting off the cover.
2.Load the batteries, making sure the polarities (+) and
3.Snap the cover back in place.
1
2
The remote control requires two AA alkaline batteries.
Care of the Remote Control
•Use only alkaline batteries.
•Be within 20 feet of the equipment.
•Do not press two or more buttons at the same time unless instructed to do so.
•Do not allow unit to get wet or become heated.
•Avoid dropping on hard surfaces.
•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.
•Do not mix old and new batteries.
•Do not heat, take apart, or throw batteries into fire.
TV Tips
Turning the TV On or Off
To turn the TV on or off, point the remote control at the front of the TV and press the POWER button. Alternatively, press the POWER button on the front panel of the TV.
If You Turn Off the TV by Mistake
1.Press POWER again within about 30 seconds, while the lamp is still hot, to have the TV come back on immediately.
2.If the LAMP indicator starts blinking (about 30 seconds after you shut off power), wait about one minute for the LAMP indicator to stop blinking and press POWER to turn the TV on again.
Controlling Sound Volume
Press VOL 
/
to adjust the sound level.
Changing Channels
To change channels:
• Enter the channel number using the number keys on the remote control and press ENTER. For a
digital channel, such as
CANCEL
adash (separator).
•Press CH 
/
to change channels one channel at
atime.
•Press and hold CH 
/
to move quickly through channels.
•Press QV (QuickView) to switch back to the previ- ously tuned channel.
•Use the FAV (Favorites) feature to set up lists of favorite channels and tune to them with the FAV key. See “Channel Menu” in chapter 5.
NOTE: Memorize channels to make finding channels easier.
