Motorola SSETM 5000 service manual Display Description Appears, Esn

Performance Checks: Radio Test Mode 4-3

Table 4-2. Test-Mode Displays

Display	Description	Appears
SERVICE	The radio has entered test mode.	Always
HOST VER, followed	The version of host firmware	Always
by the version number
DSP VER, followed by	The version of DSP firmware	Always
the version number
SECURE, followed by	The version of encryption firmware	When the radio is secure
the version number		equipped
KG, followed by the	Type of encryption algorithm being used	When the radio is secure
encryption type*		equipped and at least one
		encryption algorithm is installed
(Model number)	The radio’s model number, as	Always
	programmed in the codeplug
(Serial number)	The radio’s serial number, as programmed	Always
	in the codeplug
(ESN)	The radio’s electronic serial number, as	Always
	programmed in the codeplug
(ROM size)	The memory capacity of the host FLASH	Always
	part
FLASHCOD, followed	The FLASH codes, as programmed in the	Always
by the FLASH code(s)	codeplug
UHFL	The RF band in which the radio operates	Always
Tuning Version	The default tuning data version	Always
Processor Version	The processor type and ROM version	Always
RF TEST	The radio has completed test mode.	Always

* There is a KG display for as many algorithms as are installed in the radio. If there are no encryption algorithms installed, the radio displays “KGNONE” during the test- mode display sequence.

NOTE: All displays are temporary and will expire without any user intervention. If information is longer than the physical length of the radio’s display, the information will wrap around to the next display.

3.Do one of the following:

•Press the green button on the control top to stop the displays and enter the RF test mode. The test mode menu option “1 CSQ” is displayed, indicating test frequency 1, Carrier SQuelch mode. See Section 4.2.2: “RF Test Mode” on page 4-4.

OR

•Press the top side button to stop the displays and select the control top test mode. The test mode menu option “CH TEST” is displayed, indicating that you have selected the control top test mode. See Section 4.2.3: “Control Top Test Mode” on page 4-5.

NOTE: Each press of the top side button toggles between “CH TEST” and “RF TEST”.

6881094C12-A November 11, 2004