Motorola SSETM 5000 Remove the Channel Select Knob, Install the Channel Select Knob

Disassembly/Reassembly Procedures: Disassembly/Reassembly Procedures for Radio Knobs 7-11

7.5.1Channel Select Knob

This section explains how to remove and install the Channel Select knob.

NOTES:

•Remove the battery from the radio before removing or installing the Channel Select knob.

•The Channel Select knob is a two-part kit, consisting of a knob and an insert. Once an insert is removed, it cannot be used again. Therefore, remove an insert only if the channel select switch must be replaced, or if the control top must be removed from the chassis.

•When the channel select insert must be removed, a new one must be used for reassembly.

7.5.1.1Remove the Channel Select Knob

1.Hold the radio so that the top of the radio faces upward, and the front of the radio faces you.

2.Grasp the Channel Select knob (32) and pull it upward, while rocking the knob back and forth, until it is free from the Channel Select knob retainer insert (36), or the insert is free from the shaft.

3.To remove the knob retainer insert (36), place the tip of a thin-bladed screwdriver into the slot of the insert, and pry the insert open by twisting the screwdriver. This will allow you to easily remove the insert from the channel select switch shaft. Discard the removed insert.

7.5.1.2Install the Channel Select Knob

1.Hold the radio so that the top of the radio faces upward, and the front of the radio faces you.

2.Place a new Channel Select knob retainer insert (36) on the channel select shaft, orienting the “TOP” marking on the insert upwards and aligning the insert’s D-shaped hole with the D- shaped shaft. Press downward firmly on the insert until the top of it is flush with the top of the channel select shaft.

3.Place the Channel Select knob (32) on the retainer insert (36), aligning the three ribs of the insert to the corresponding slots on the inside of the knob. Press downward firmly on the knob until it seats securely in place.

7.5.2Volume Knob

This section explains how to remove and install the Volume knob.

NOTES:

•Remove the battery from the radio before removing or installing the Volume knob.

•The Volume knob is a two-part kit, consisting of a knob and an insert. Once an insert is removed, it cannot be used again. Therefore, remove an insert only if the volume control must be replaced, or if the control top must be removed from the chassis.

•When the volume insert must be removed, a new one must be used for reassembly.

7.5.2.1Remove the Volume Knob

1.Turn the Volume knob (33) to the off position.

2.Hold the radio so that the top of the radio faces upward, and the front of the radio faces you.

3.Grasp the Volume knob (33) and pull it upward, while pushing it toward the back of the radio, until it is free from the Volume knob retainer insert (37), or the insert is free from the shaft.

4.To remove the knob retainer insert (37), place the tip of a thin-bladed screwdriver into the slot of the insert, and pry the insert open by twisting the screwdriver. This will allow you to easily remove the insert from the volume control shaft. Discard the removed insert.

6881094C12-A November 11, 2004