MSI MS-9246 manual Configure/View Scsi Controller Settings, Scsi Bus Interface Definitions

MS-9246 1U Rackmount Server

Configure/View SCSI Controller Settings

There are 8 items in the “Configure/View SCSI Controller Settings” screen. These items display or allow you to change the SCSI controller’s settings. Use the arrow keys to highlight the item and then press <Enter> to select the value you want in each item or enter each item’s sub-menu screen.

AIC-7902 A at slot 0D, 03:07:00
Options
SCSI Bus Interface Definitions
SCSI Controller ID	7
SCSI Controller Parity	Enabled
SCSI Controller Termination	Enabled
Additional Options
Boot Device Configuration	Press <Enter>
SCSI Device Configuration	Press <Enter>
Advanced Configuration	Press <Enter>
<F6> -- Reset to SCSI Controller Defaults
BIOS Information
Interrupt (IRQ) Channel	11
I/O Port Address	B000h, B400h

SCSI Bus Interface Definitions

SCSI Controller ID

The item is used to assign a SCSI ID to the SCSI controller. It is recommended that you should leave the default setting unchanged. Settings: [0]~[15].

SCSI Controller Parity

Use the field to enable or disable SCSI parity error checking function. If any of your SCSI devices does not support parity checking, disable this function. While disabling the function, you should disable disconnections for all devices, as parity checking for the reselection phase is NOT disabled. A non-parity device’s I/O operation will never complete if the reselection fails due to a parity error.

SCSI Controller Termination

In order to have the SCSI bus function properly and reliably, termination at the ends of

A-4