
MS-9246 1U Rackmount Server
Installing the Driver
This section describes installing the driver and setting up the new array for the drives attached to your controller. Before you get started, you need to select from the following scenarios for installing the controller driver on Windows or Linux systems:
Installing the Driver in a New Windows System
Installing the Driver in an Existing Windows System
Installing Red Hat Linux 7.3 or 8.0
Installing SuSE Linux 8.0 or 8.1
1. Installing the Driver in a New Windows System
In this scenario, you are installing the driver in a new system that has no operat- ing system. To install the driver:
1.Create a driver disk by following the instructions from the Web site or the product CD.
2.Restart the computer.
3.If creating an array, press
4.When the array is finished building or if you are continuing from Step 3, insert the Windows setup CD and restart the system.
5.Press F6 when prompted to install a
MSI Reminds You...
When F6 is active, a prompt appears at the bottom of the screen. Press F6 immediately — you only have 5 seconds. If you miss your chance, restart this Windows installation to complete it correctly. Otherwise, Windows will not recognize your controller.
6.Insert the driver disk you created in Step 1 and wait until prompted to install a driver.
7.Press S to specify that the driver is on the floppy disk, and press Enter. Windows searches the disk for a suitable driver.
8.When the Adaptec Embedded Serial ATA HostRAID driver is found, press Enter. Follow the remaining