Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F) 29
PPP Enable/disable PPP. The default is Enable.
Dial-on-Demand: Enable/disable Dial-on-Demand. The default is Enable. If you disable it, the modem
will always stay connected.
Idle Time Out: Set the amount of idle time that will pass before the modem will timeout. The
default is 180 seconds.
Connect Time Out: Set the number of seconds to wait for a connection while in receive mode before
timing out.
Dialing Max Retries: Enter the number of dialing retries allowed. The default is zero, which means an
infinite number is allowed. Range 0 to 100.
Authentication Authentication Type: Set the authentication protocol type that will negotiate with the remote peer:
pap/chap/pap-chap. Default is pap-chap.
User Name: Enter the User Name with which the remote peer will authenticate. Default is
ipmodule. You can leave this field blank, if desired.
Password: Enter the Password with which the remote peer will authenticate. Default is
ipmodule. You can leave this field blank, if desired.
ICMP Keep Alive Check Keep Alive Check: Enable/disab le Keep Alive Check. The default is Disable.
Keep Alive Type: Select ICMP or TCP (the protocol type for Keep Alive).
Host Name: Enter the Host Name or IP Address for Keep Alive Check. No default.
TCP Port: Enter the TCP Port number to connect with the TCP server.
Interval: Set the number of seconds for Keep Alive Check. Default is 30 seconds.
ICMP Count: Set the number of ICMP Keep Alive Checks to be sent to the specified host. Default
is 10.
Modem Configuration (Refer to the Customer Activation Notices included with the product for proper
information to enter).
Baud Rate: Set the serial baud rate. Default is 115200.
Dial Number: Set the dial number to be dialed. Default is NULL.
For EDGE or GPRS the number is *99***1#.
For CDMA the number is #777.
Dial Prefix: Set the modem dial prefix. The default is ATDT.
Connect String: Set the modem Connect String. The default is CONNECT.
APN: For GPRS and EDGE, enter the APN (Access Point Name). The APN is assigned
by your wireless service provider.
Init String: Configure the modem init strings. You can set up to 4 modem initializ ation strings.
Submit Button Click the Submit button to save these settings. Note: You must click Save and Restart once you have
completed and submitted all the screens on which you have made changes.