Chapter 3 – Using the Web Management Software
3.On the Packet Filters > DNAT Configuration screen, define the DNAT rule.
Source – Select the original target network/host of the IP packets that you now want rerouted. The original target network/host is the one previously defined in the Network Configuration section.
Example: Any
Pre DNAT Service – Select the service for the
Example: MeterPort
Post DNAT IP – Select the destination to which the IP packets are to be diverted. Only one host can be defined as the Post DNAT destination.
Example: MeterIP
Post DNAT Service – Select the service for the Post DNAT configuration. Example: MeterPort
Internal Source – Select the source address for packets that going to be sent. If you do not want to change the address, select NOCHANGE.
Example: NOCHANGE
4.Save – Click the Save button to save this configuration. Note: You must click Save and Restart once you have completed and submitted all the screens on which you have made changes. The device will save all the settings and reboot the PC.
39 |
