Multi-Tech Systems RF802EW Modem String Settings, Dial-up/Hang-up Settings, RouteFinder Manager

Chapter 5 - RouteFinder Manager

12	Hangup	Hangs up Modem
13	Send ‘AT S0=1’	Sends initial string ‘AT SO=1’ to modem

14Send ‘ATDT 8885678’ Dials phone number 888-5678 (ISP #2)

15Wait ‘Connect’ 23 Waits for ISP to send reply ‘CONNECT’. If no CONNECT, goes to line 23.

16Wait ‘username:’ 23 Waits for ISP to send reply ‘username’. If no response, goes to line 23.

17	Send ‘Stephen’	Sends the username ‘Stephen’ to ISP
18	Wait ‘password:’	Waits for the ISP to send ‘password:’
19	SH ‘5678’	Sends password ‘5678’ to ISP
20	Wait‘====>‘	Waits for ISP to send reply ‘===>‘
21	Send‘1‘	Selects option 1 (PPP) for this ISP
22	Go	Starts PPP mode
23	Hangup	Hangs up Modem
24	Jump 2	Goes back to line 2 to re-dial ISP #1

Modem String Settings

The most important modem string is the initialization string because your network device uses it to establish communications with your modem or ISDN TA. The modem initialization string displayed is the modem or ISDN TA initialization string entered in the Setup Wizard. For most analog modems, the Standard Modem selection will work. For additional information, refer to the Modem Settings information presented in the Software Installation and Configuration Chapter of this User Guide.

Important: There is no standard ISDN TA initialization string. If your ISDN TA is not included in the modem list, check your ISDN TA User’s Guide for information for the initialization string for an Asynchronous to Synchronous PPP connection. If you are using only one channel of your ISDN connection, you can enter the Async to Sync PPP initialization string. If you are bundling your connection channels, use a Multilink-PPP initialization string. You must also enter the two phone numbers in the Telephone Number box of the General Settings dialog box. Also verify that your ISDN TA supports the dial-up string ATDT. Most ISDN TAs support ATDT, but some support ATD or ATDI.

Dial-up/Hang-up Settings

The Dial-up/Hang-up settings allow you to specify your connection time (idle timeout or auto reconnect) and the number of times to attempt to connect if a connection cannot be established.

1.From the main Manager dialog box, click Port Settings.

2.Click Dial-up/Hang-up Settings. The Dial-up/Hang-up Settings dialog box displays.

45