Radio Remote Control Programming
Before starting operation of the Radio Remote Control, go to Screen 9 of the Digital Readout Screen:
RADIO ADDRESS 9
NO RADIO
PRESS RESET TO
LEARN A NEW ONE
1.Press the ON/OFF button on the radio (wireless) remote control to turn on the power. Hold down the RESET switch. The display will now show:
RADIO ADDRESS 9
NOW SCANNING
FOR NEW
TRANSMITTER
2.After 5 seconds, the display will show:
RADIO ADDRESS 9
COMMUNICATING
PRESS RESET TO
LEARN A NEW ONE
3. The remote control is now ready for use.
Cable Remote Control
Installation of the Cable Remote Control Assembly
Connect the cable to the front panel of the control box (See Figure 38).
CABLE REMOTE CONTROL UNIT
25 FT. CABLE
PUMP REV
PUMP ON/OFF |
|
|
| TO CONTROL BOX |
CONNECTOR
Figure 38. Cable Remote Control
LS600 PUMP — OPERATION
Cable Remote Control Operation
Before using cable remote control, set the pumping volume with the VOLUME switch on the control box then move the Pumping Control Switch on the control box to the REMOTE position.
The cable remote control (Figure 38) has the following controls.
PUMP ON/OFF - Starts and stops the forward pumping.
PUMP REV - starts pumping in reverse direction.
WARNING -TRANSPORTING PUMP
It will be necessary at times to move your pump from one job site location to another. Before moving the pump, make sure to pump the remaining concrete out of the hopper. Moving the pump with a full hopper of concrete can cause severe damage or breakage of the axle and axle springs, excess strain and pressure on the hub and bearing assembly.
Leaking manifold seals or hose coupling gaskets which leak water can cause sepa- rationandsubsequentjammingatthatpoint.
MAYCO LS600 PUMP — OPERATION AND PARTS MANUAL — REV. #4 (9/15/11) — PAGE 31