35
6.3GLASS / DOOR REPLACEMENT
!WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
6.3.1Place the door frame face down careful not to scratch the paint.
6.3.2Center the gasketed glass inside the door frame with the thick side of the gasket facing up.
6.3.3Bend the glass retainers located along the edge of the door frame over the gasket holding the glass in place. Be careful not to break the glass.
FIGURE 6.3
56.1
GASKET
GLASS
GLASS
RETAINER 
DOOR
FRAME
6.4LOG PLACEMENT
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. Phazertm logs glow when exposed to direct flame and provide a unique and realistic glowing effect. Use only certified phazertm logs available from your Napoleon® dealer.
5
1
4
3
2
Place log #1 onto the burner, centering it onto the burner tray and pushing it as close to the rear wall of the firebox as possible. Move logs # 2 and 3 into po- sition, lining up the studs located on the burner with the holes on the bottom of the logs. Sit the notch at the bottom of log #4 against the left outermost grate post and position the top of the log into the pocket provided on the rear log (#1).
The notch in log #5 should be pressed down onto the skewering pin located at the end of the grate as shown to prevent it from rocking.
