NETGEAR FVS318N-100NAS 3. Enter the settings as explained in the following table: , 4. Click Apply to save your settings. The new static route is added to the Static Routes table.

LAN Configuration

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Figure 48.

3. Enter the settings as explained in the following table: 4. Click Apply to save your settings. The new static route is added to the Static Routes table.

Table 23. Add Static Route screen settings for IPv4

Setting Description

Route Name The route name for the static route (for purposes of identification and

management).

Active To make the static route effective, select the Active check box.

Note: A route can be added to the table and made inactive if not needed. This

allows you to use routes as needed without deleting and re-adding the entry. An

inactive route is not advertised if RIP is enabled.

Private If you want to limit access to the LAN only, select the Private check box. Doing so

prevents the static route from being advertised in RIP.

Destination IP Address The destination IP address of the host or network to which the route leads.

Subnet Mask The IP subnet mask of the host or network to which the route leads. If the

destination is a single host, enter 255.255.255.255.

Interface From the drop-down list, select the physical or virtual network interface (WAN,

LAN, or DMZ interface ) through which the route is accessible.

Gateway IP Address The gateway IP address through which the destination host or network can be

reached.

Metric The priority of the route. Select a value between 2 and 15. If multiple routes to the

same destination exist, the route with the lowest metric is used.