Setting the Exposure mode—continued Shooting Mode
Check point
If the shutter speed is displayed in red when 1/2000 sec. shutter speed is selected,
Exposure status | Control panel | Monitor |
Correct exposure
1 EV under
2 EV over
Long time (BULB) exposure (up to 60 sec.)
ÅSet the Exposure mode to Â, and place the camera on a tripod or secure
position, then rotate the Command dial to set the shutter speed indication to bu1b (next after 8 sec.) to enable long time (BULB) exposure.
ÍPressing the Shutter release button once opens the shutter up to 60 sec.
•BULB can only be set when Single mode is selected in the Continuous Shooting menu (p. 99).
•The Speedlight is canceled if BULB exposure is set.
•During
Setting the Flash Mode | Shooting Mode |
Four Flash modes are available for use in various flash shooting situations.
Condition in which Flash mode can be set
Flash mode can only be set when the
1 Slide the Speedlight release lever to release the
Note: If flash does not fire
The Speedlight does not fire with Infinity focus (p. 61), in Continuous Shooting mode (other than Single mode) (p. 99), in Best Shot Selector mode (p. 102), Lens mode (p. 106) or Int Flash Off mode (p. 133) even when the
2 Press the Flash mode button repeatedly until the desired Flash mode appears.
* No indication is shown in the Monitor when AUTO Flash mode is selected.
•If the Red LED is pulsing slowly when the Shutter release button is lightly pressed, the Speedlight is not fully charged and the shutter cannot be released. Wait until the Speedlight is fully charged and release the shutter again.
Detailed Operation
68 | 69 |