Chapter 12: VSM-6802 Digital Composite Video Signal Monitor Module

Installation

 

 

Installation

The VSM-6802 Video Signal Monitor can be installed into a 6800 series, FR-7001 series, or FR-7000MB MIX BOX series frame. When the VSM-6802 module is installed into an FR-7001 series or FR-7000MB MIX BOX frame, a matching back box module is installed on the back of the frame. When this module is installed into a 6800 series frame, only a back panel overlay is required.

 

VSM-6802-M

 

D2

 

SERIAL

 

INPUT

PAL/NTSC

SERIAL

OUTPUTS

OUTPUTS

The back box is used when the VSM-6802 module is installed into either an FR-7001 series or FR-7000MB MIX BOX frame

VSM-6802

 

D:2

SERIAL

INPUT

2

1

SERIAL OUTPUT

4

3

2

1

PAL/NTSC OUTPUT

4

3

This overlay is used when the VSM-6802 module is installed into a 6800 series.

Figure 12-2. Back Module and Overlay

Operation

The two LEDs located on the front of the module indicate the status of the incoming data:

DATA_PRES LED indicates a 143 MHz signal.

SYN_PRES LED indicates that TRSID has been detected on the input signal.

The Video Output Level multi-turn potentiometer is used to adjust the output composite analog video level. Terminate an output with 75￿ and adjust the pot to get a 1 Vp-p waveform.

108

6800/7000 Series - Distribution and Routing Products Installation and Operation Manual

Page 135
Image 135
Nokia 7000 Series, 6800 Series operation manual Back Module and Overlay