Nokia 7000 Series Controls and Indicators, Status LEDs, Default Settings, Switch Function

Chapter 4: USM-6800 PAL/NTSC Monitoring Encoder Module Controls and Indicators

Controls and Indicators

The controls and indicators described in the tables below are located at the front edge of the module.

Switch	Function
16-position rotary switch	Selector
3-position up/down	Adjuster
momentary switch
Gain and frequency multi-turn	Adjuster
potentiometer

Status LEDs

LEDs	Function
625 Auto 525 LED	When this Green Auto LED is on, this
	indicates the detected standard. When the
	Auto LED is off, this indicates a forced line
	standard.
Error LED	This Red LED indicates: there is loss of
	video, the forced line standard is different
	than the detected standard, or there is a
	missing or mispositioned EAV-timing
	reference signal in the digital data.

Default Settings

The USM-6800 is shipped with the following default settings:

LEDs	Function
Standard	Set to Auto
Output	Set to Component YUV
V Blanking	Set to Pass
Setup	Set to On
Burst	Set to On
Chroma	Set to On

38 6800/7000 Series - Distribution and Routing Products Installation and Operation Manual