Nokia 6800 Series, 7000 Series operation manual Mode Select Switch Toggle Switch, Reserved

User Interface Chapter 4: USM-6800 PAL/NTSC Monitoring Encoder Module

User Interface

Data is stored to the *EEPROM under the following conditions:

￿Any change in the Mode Select switch position, only if data has changed.

￿After 30 seconds of inactivity, only if data has changed.

There are discrete sets of data for 525 and 625; only the data for the standard in use is stored.

**In the Component configuration, one composite output is generated as well as the RGB or YUV analog outputs.

The following chart describes the Mode Select switch and Toggle switch functions:

Mode Select Switch		Toggle Switch
Position	Function	Down	Up
0	Operate	• Normal operation; Toggle switch disabled.
		• Store any changed settings to *EEPROM.
1	Standard	Force: Forces the	Auto: The
		configuration of the	configuration of the
		board into 525 or 625	board 525 or 625 line
		line standard	standard depends on
		depending on position	the detected standard.
		2 of Mode Select switch
		configuration.
2	Force	625: Forces the board	525: Forces the board
	Standard	configuration into the	configuration into the
		625 line standard.	525 line standard.
		Position 1 of the Mode	Position 1 of the Mode
		Select switch should be	Select switch should be
		configured for the	configured for the
		Force mode.	Force mode.
3	RESERVED
4	Output	Component: Generates	Composite: Generates
		RGB or YUV analog	the YC=2 composite or
		outputs depending on	Y composite analog
		position 6 of the Mode	outputs depending on
		Select switch	position 5 of the Mode
		configuration.**	Select switch
			configuration.

6800/7000 Series - Distribution and Routing Products Installation and Operation Manual 39