Nortel Networks 207344-B manual Seating the Module

Installing the EtherSpeedII Switch Modules

5.To seat the module onto the backplane, push the inserter/extractor levers inward toward the module (Figure 3-5).

6537FA

Figure 3-5. Seating the Module

When the front panel of the module is flush with the front of the chassis, the module backplane connectors are properly seated.

6.Use the flat-tip screwdriver to tighten the captive retaining screw at each end of the module front panel.

Note: The captive retaining screws on the module must be tightened to at least 2 inch-pounds, but no more than 4 inch-pounds, of torque. Finger tightening is also adequate. Do not overtighten.

207344-B 3-5