Nortel Networks 207344-B manual Installing the Replacement Switch Module

Using the Centillion EtherSpeedII Switch Modules

5.Slide the switch module out of the chassis (Figure 3-9).

Hold the front panel with one hand while you support the bottom of the switch module with the other hand.

6471

Figure 3-9. Removing the Module from the Centillion 50/100 Chassis

6.Place the switch module on an antistatic mat until you are ready to put it back into the chassis.

7.If you are not installing another switch module of the same model, install a filler panel over the empty slot.

Installing the Replacement Switch Module

To install the replacement switch module, follow the procedure described in “Installing a Switch Module” on page 3-2.

Reconfiguring the Replacement Switch Module

The EtherSpeedII 10/100BASE-T and the EtherSpeedII 100BASE-FX switch modules keep the configuration of an identical replacement module. If the replacement is not of the same model type, you must reconfigure the module after it is replaced. Follow the procedure described in “Checking LEDs on the Switch Modules” on page 3-2.

3-10 207344-B