Nortel Networks 214393-A manual VLAN tab for multiple ports

84Chapter 3 Configuring and graphing ports

Table 31 Interface tab fields for multiple ports (continued)

Field	Description
OperStatus	Current operational state of the interface, which can be one of the
	following:
	•	up
	•	down
	•	testing
	If AdminStatus is up, then OperStatus should be up if the interface is
	ready to transmit and receive network traffic. If AdminStatus is down,
	then OperStatus should be down. It should remain in the down state if
	and only if there is a fault that prevents it from going to the up state.
	The testing state indicates that no operational packets can be passed.
LastChange	Value of the time the interface entered its current operational state. If
	the current state was entered prior to the last reinitialization of the local
	network management subsystem, the value is zero.
Speed	The estimate bandwidth of the interface in bits per second (bps). For
	interfaces that do not vary in bandwidth or have no way to estimate the
	bandwidth, this object should contain the nominal bandwidth. If the
	bandwidth of the interface is greater than the maximum value reported
	by the object, then the object displays its maximum value
	(4,294,967,295). For a sub-layer that has no concept of bandwidth, the
	object should be zero.
AutoNegotiate	Indicates whether the port is enabled (checked) for autonegotiation or
	not.
AdminDuplex	The administrative duplex mode of the port (full).
OperDuplex	Indicate duplex value of the port.
AdminSpeed	The speed of a port: 1000 mbps
OperSpeed	The current operating speed of the port.
MltId	The MultiLink Trunk to which the port is assigned (if any).

VLAN tab for multiple ports

The VLAN tab shows the VLAN membership for the selected ports.

To view or edit the Interface tab for multiple ports:

1Select the ports that you want to edit.

[Ctrl] + left-click the ports that you want to configure. A yellow outline appears around the selected ports.

214393-A