October 2006 | Preinstallation requirements |
Replacing the side cover
Introduction
When you are satisfied that the server was not damaged during shipment, reinstall the side cover.
To replace the side cover
CAUTION
Risk of equipment damage
Ensure that there are no tools or loose parts inside the server chassis before replacing the side cover.
1Align the right edge of the server side cover with the inside ledge at the front of the server.
2Ensure that the cover lays flat along the side of the server.
3Insert the tabs along the top and bottom edges of the server side cover inside the slots along the top and bottom of the server.
4Push the cover towards the front of the server until the tabs firmly engage in the chassis.
Note: When correctly engaged, the cover clicks into place.
5Tighten the two thumbscrews on the back of the server.
703t Server Hardware Installation | 43 |
