Nortel Networks 703t manual Server in the Installation and Configuration

October 2006 703t server description

The table below describes the parts that are identified in the preceding diagram:

Part	Function
Reset button	Triggers a hardware (cold) reset. Do not use
	this button to perform a server restart. Restart
	the server as described in “Restarting the
	server” in the Installation and Configuration
	Task List (555-7101-210).
Network	Left: 10/100Base-T controller LED
controller LEDs	(NIC1 10/100 MB: ELAN
(green)	for Meridian 1*/Succession 1000* connection)
	Right: 10/100/1000Base-T controller LED
	(NIC2 1 GB: CLAN
	for Customer LAN connection)
Sleep mode button	Not used
Power button	Turns the server’s power on or off.
Status LEDs	Indicates when the server is powered up and
	the disk drives are active.
	„	Left: hard drive activity LED (not used)
	„	Center: power/sleep LED (green)
	„	Right: status LED (bi-color) indicates
		whether the server is functioning properly,
		or whether a hardware event has occurred.
USB connector	For future use
Floppy disk eject	Ejects the floppy disk.
button
Floppy drive	Drive for 3-1/2 inch diskettes.

703t Server Hardware Installation 19