Nortel Networks 703t manual Connecting the server to the Elan

Installing the server and connecting the peripheral devices Standard 1.04

Connecting the server to the ELAN

Connect the CallPilot server to the Meridian 1 switch or Succession 1000 system using the Embedded LAN (ELAN).

ATTENTION	For important considerations about using the ELAN in
	your network, see the Planning and Engineering Guide
	(555-7101-101).
ATTENTION
	To comply with EMC requirements, a Class A hub must
	be located 10 m (33 feet) away from the 703t server.

To connect the server to the ELAN (Meridian 1 or Succession 1000 only)

1Locate the ELAN Ethernet connector on the back of the server.

Note: The ELAN connector is labeled as NIC1 10/100 MB. For the connector location, see the diagram on page 54.

2Connect an RJ-45 network cable from the ELAN hub to the server’s ELAN connector.

Note: The ELAN hub is optional if you use a cross-over network cable to make a direct point-to-point connection from the server to the switch. However, if you choose to establish a direct point-to-point ELAN connection, no other device can connect to the ELAN.

58 CallPilot