Nortel Networks 703t manual Inspecting the server interior, To inspect the server interior

Preinstallation requirements Standard 1.04

Inspecting the server interior

Introduction

Before you install the server, you should perform a visual inspection for loose components, foreign matter, or shipping damage inside the server.

CAUTION

Risk of equipment damage

When working with interior components, use an ESD wrist strap to protect static-sensitive components.

To inspect the server interior

1Ensure that all the cards are fully seated on the baseboard.

2Check for any loose wires or foreign objects, such as loose screws, inside the chassis.

3Review the slot locations (see “Rear panel diagram” on page 21).

4Do one of the following:

IF	THEN
you observe	contact your Nortel technical support
any damage	representative.
components have	secure them. Then replace the server
become loose	side cover and proceed with the
	hardware installation.
	Refer to the procedures in CallPilot 703t
	Server Maintenance and Diagnostics
	(555-7101-227).
you are satisfied that the	replace the server side cover.
703t server has arrived at	For instructions, see “Replacing the side
your site undamaged
	cover” on page 43.

42 CallPilot