99
Maintenance
Contents This section contains information about the following topics:
"Introduction" (page 99)
"CS 1000 CLI commands" (page 99)
"MCS 5100 tools" (page 101)
"Translation Verification tool" (page 101)
IntroductionThis section contains CS 1000 Command Line Interface (CLI) commands
that can be used with CDS. The CS 1000 CLI commands are used from the
Signaling Server CLI.
This section also contains a diagnostic tool available on MCS 5100 for
verifying translations.

CS 1000 CLI commands

The CS 1000 Signaling Server provides a Command Line Interface (CLI)
through a serial port or a Telnet session. This section contains the CLI
commands available at that interfacethat are applicable to CDS.
Signaling Server CLI commands are available at three levels:
•Level One — Operations, Administration, and Maintenance (OAM)
shell for basic technician support and general status system checking
(oam>prompt)
•LevelTwo — Problem Determination Tool (PDT) shell for expert support;
also includes all Level One (OAM) commands (pdt>prompt)
•Level Three — Nortel proprietary vxWorksª shell for advanced
debugging and design support (prompt)
Note: This section describes the Level One (OAM) and LevelTwo
(PDT) CLI commands. Level Three commands are considered expert
support and design level commands, and are not documented here.
Nortel Communication Server 1000
Communication Server 1000 to MCS 5100 ConvergedDesktop Type 2 Configuration Guide
NN43001-321 01.05 Standard
Release 5.0 15 February 2008
Copyright© 2005-2008, Nor tel Networks
.