14Common TOPS VSN log messages (0201)
Action: If the PRU is in the working state, no action is required. If the PRU is in the faulty state, document the problem, restart both sending and receiving PRUs, and then contact NT.
0002/0004 Message: [Sending_PRU_name] was trying to communicate with [Receiving_ PRU_name] but could not. Either a bad control block handler or a bad taskID could cause such an error.
Description: The sending PRU could not communicate with the receiving PRU. The latter did not accept the message. It is the responsibility of the sending PRU to recover from the error by resending the message or to declare itself faulty.
Action: If the PRU is in the working state, no action is required. If the PRU is in the faulty state, document the problem, restart both sending and receiving PRUs, and then contact NT.
0002/0005 Message: [Sending_PRU_name] was trying to communicate with [Receiving_ PRU_name] but could not. The receiver of the message [Receiving_PRU_ name] is probable cause of error.
Description: The sending PRU could not communicate with the receiving PRU. The latter did not accept the message. It is the responsibility of the sending PRU to recover from the error by resending the message or to declare itself faulty.
Action: If the PRU is in the working state, no action is required. If the PRU is in the faulty state, document the problem, restart both sending and receiving PRUs, and then contact NT.
0002/0006 Message: [Sending_PRU_name] was trying to communicate with [Receiving_ PRU_name] but could not. This means the message was not accepted after a timeout value.
Description: The sending PRU could not communicate with the receiving PRU. The latter did not accept the message after a specified time interval. It is the responsibility of the sending PRU to recover from the error by resending the message or to declare itself faulty.
Action: If the PRU is in the working state, no action is required. If the PRU is in the faulty state, document the problem, restart both sending and receiving PRUs, and then contact NT.
0002/0007 Message: [Sending_PRU_name] was trying to communicate with [Receiving_ PRU_name] but could not. The sender encountered an invalid wait time.
Description: The sending PRU could not communicate with the receiving PRU. The latter did not accept the message after a specified time interval. It is the responsibility of the sending PRU to recover from the error by resending the message or to declare itself faulty.
Action: If the PRU is in the working state, no action is required. If the PRU is in the faulty state, document the problem, restart both sending and receiving PRUs, and then contact NT.
