Olivetti 16W, 20W Interrupting a Copy RUN, Press the Interrupt key to interrupt the copy run

INTERRUPTING A COPY RUN

(Interrupt copying)

A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished, the copy run will resume using the original copy settings.

Note Interrupt copying is not possible when the user programs are being configured.

1 Press the [INTERRUPT] key () to interrupt the copy run.

	The INTERRUPT
	indicator will light up and
INTERRUPT	the machine will revert to
	the initial settings. (p.12)
	The INTERRUPT
	indicator will blink until
	the current copy run
	stops.

• If the SPF is being used, the copy run will

Note not stop until the set number of copies is completed.

•If "Auditing mode" is enabled:

"- - -" will appear in the number of copies display. Enter your 3-digit account number. Copying will not be possible unless a correct account number is entered. (p.39)

2 Remove the previous original(s) and place the original(s) of the interrupt copy job.

3 Set the number of copies and other copy settings and then press the [START] key ().

4 When the copy job is finished, press the [INTERRUPT] key () and remove the original(s).

The INTERRUPT indicator will go off, indicating that the interrupt function is no longer operating. The copy settings will automatically revert to the settings selected for the copy run before the run was interrupted.

5 Replace the previous original(s) and press the [START] key ().

The interrupted copy run will resume.

28