Olivetti 16W, 20W Indicators And Display Messages, When Use close paper size is disabled

INDICATORS AND DISPLAY MESSAGES

If one of the following indicators lights up or one of the following messages appears in the display, check the meaning of the indicator or message in the following table and take appropriate action.

	Toner cartridge replacement			Developer replacement required indicator
	required indicator
	Maintenance indicator					Display
	Paper required indicator				Misfeed indicator
	Indication				Cause and solution		Page
	Maintenance	Steadily	Service by an authorised OLIVETTI service technician is				–
	indicator	lit	required.
	Developer	Steadily	Developer is required. Contact your authorised service
	replacement						–
		lit	representative.
	required indicator
	Toner cartridge	Steadily	Replacement of toner cartridge will be needed soon.				–
	replacement	lit	Prepare a new cartridge.
	required indicator	Blinking	Toner cartridge must be replaced. Replace it with a new one.				54
	Paper required	Steadily	The tray is out of paper. Load paper. It is also possible that
			the tray is not inserted completely into the machine. Make				14
	indicator	lit
			sure it is inserted correctly.
	Misfeed indicator	Blinking	A paper misfeed has occurred. Remove the misfeed as				47
			explained in "MISFEED REMOVAL".
ORIGINAL SIZE indicator			The original is not placed in the correct orientation. Rotate
		Blinking	the original so that it is in the same orientation as the				18,19
			blinking ORIGINAL SIZE indicator.
			A blinking PAPER SIZE indicator means that the size of paper
			loaded in the tray is different from the paper size setting for the tray.
PAPER SIZE indicator		Blinking	Change the paper size setting.				16
			To clear the display, do one of the following:

•Use the [TRAY SELECT] key ( ) to change the tray selection.

•Open and close the tray.

•Press the [CLEAR ALL] key ( ).

		Steadily	The front cover or the side cover is open. Close the front	–
		lit	cover or the side cover.
[CH] appears in display			The toner cartridge is not installed correctly. Reinstall the
		Blinking	toner cartridge. If [CH] still blinks in the display after	54
			reinstalling the toner cartridge, contact your authorised
			service representative.
			Turn off the power switch, wait about 10 seconds, and then
	Letters and numbers appear		turn on the switch again. If this does not clear the message,
			write down the code that appears and then unplug the	–
	in the display		power cord and contact your authorised. Tell service
			representative what code appeared and the circumstances
			under which it appeared.
When "Use close paper size" is disabled
			Press the [TRAY SELECT] key ( ) to manually select the
	A3		tray and then press the [ON LINE] key ( ). Printing will	Online
	A4		begin. If you are selecting the bypass tray, load paper in the	manual
	A4
	A5		bypass tray.
	B4
	EXTRA

46