6Troubleshooting Guide
Problem
The thermometer resets itself unexpectedly. The emissivity has been reset to .95. All other parameters are reset to the default values.
Solution
The trigger is pulled two times in rapid sequence. Wait at least 2 seconds between two successive trigger pulls. You may need to set the emissivity, low alarm, high alarm, target ambient temperature values again.
Laser Sighting |
|
|
| ||
|
|
|
|
| |
|
| Problem | Solution |
|
|
|
| No Laser Beam | 1. Make sure the trigger is pulled | ||
|
|
| and the laser power switch is | ||
|
|
| turned on. (The red power LED | ||
|
|
| should be lit). | ||
|
|
|
|
| |
|
| The Laser "line of sight" | 1. The line of sight and the center | ||
|
| does not coincide | of the target are offset by design. | ||
|
| with the center of the | (refer to Figure | ||
|
| target. | explanation above it for how | ||
|
|
| to compensate for this). | ||
