Getting connected

Connecting speakers

•Connect speakers only as shown here. Incorrect connections may damage the CR-N1 and the speakers.

•The minimum impedance for each speaker is 4 ohms.

•Unnecessarily long, or very thin speaker cables may affect the sound quality and should be avoided.

•Do not connect more than one speaker to each pair of terminals.

•Turn off the CR-N1 before connecting any speakers. Failure to do so may damage the CR-N1 or the speakers.

•See page 20 for information on connect- ing the Onkyo D-N1 speakers.

Preparing the speaker cables

1.Strip 15 mm (5/8") of insulation from the ends of the speaker cables, as shown.

15mm (5/8")

2.Twist the bare wires, as shown.

•Do not connect the AC power cord to a wall outlet until you’ve completed all other connections, including antenna (see page 23).

Connecting the speakers

Speakers must be connected only as shown here.

–+ – +

Right speaker

Left speaker

Make sure that each (+) speaker terminal is connected to the correct (+) CR-N1 SPEAKERS terminal, and that each (–) speaker terminal is connected to the correct (–) CR-N1 SPEAKERS terminal. Incorrect speaker wiring will affect the sound quality and may damage the CR-N1 or the speakers.

18