Using USB

Sound control panel confirmation

In order to output audio from your Macintosh via USB, you must set the audio output as follows.

1Open the Sound control panel.2Select Output, and make sure that

“Choose a device for sound output:” is set to Built-in, as shown.

Mac OS 9.0.4

Mac OS 9.1

3Play an AIFF file or something in order to confirm that the CR-N1 is outputting sound properly.

Note that the device list you see on your Macintosh will no doubt be different to that shown here due to configuration and system differences.

If no sound is heard, disconnect the USB cable from the CR-N1, reconnect it, and then check again.

Using Platinum Sounds

In order to listen to Platinum Sounds via USB, follow the procedure below. If you do not follow this procedure, Platinum Sounds may not work properly.

1Disconnect the CR-N1 from your Macin- tosh’s USB port.2Open the Appearance control panel.

3Click the Sound tab, and set “Sound track” to None, as shown.

4Reconnect the CR-N1 to your Macin- tosh’s USB port.5Set the “Sound track” to Platinum Sounds, as shown.6Close the Appearance control panel.

57