Using USB

4To turn off the USB Mix function, press the USB MIX button again (the USB MIX ON indicator goes out and the SOURCE DIRECT indicator lights up).

The USB Mix can be heard through the speakers and headphones, but only the selected source signal is output from the

LINE OUT.

Windows USB setup

The CR-N1 USB interface supports “hot plug- ging,” so USB cables can be connected or disconnected even while your PC is on.

However, it’s recommended that you turn down the CR-N1 volume beforehand.

Use only standard USB cables that support high-speed transmission.

The following procedures and screen shots are based on Windows Me. Additional screen shots are provided where differences exist between operating systems.

System requirements

•Windows-compatible PC with a Rev. 1.0 compatible USB port.

•Windows 98, 98SE, Me, 2000 or later operating system that supports USB.

See your computer manual or consult your dealer to ensure that your PC complies with these requirements.

Checking your PC’s USB ports

Before connecting the CR-N1, it’s a good idea to check that your PC’s USB ports are working properly.

1From the Start menu, select Settings →Control panel, and open the System con- trol panel.

2Click the Device Manager tab, and then click the “View devices by type” button.

3Click the plus box next to “Universal Serial Bus controllers.”

Under “Universal Serial Bus controllers,” you should see several USB devices listed, as shown here.

Note that the device list you see on your PC will no doubt be different to that shown here due to PC specification and operating system differences. In addition, the type of USB Host Controller will be different.

A letter X, exclamation point (!), or question mark (?) to the left of a USB device name indicates that the USB device is not functioning properly. For information on how to correct this, see your computer manual or consult your dealer.

52