Onkyo CR-N1 59

		Troubleshooting


Symptom	Possible cause	Remedy

	The received signal is too	Install an outdoor FM antenna. See
FM reception is hindered by	weak?	page 24.

		Try changing the position and
hiss and the tuning and stereo	Stereo FM transmissions travel	Try changing the position and
hiss and the tuning and stereo	Stereo FM transmissions travel	direction of the outdoor antenna.
indicators are ﬂashing.	only half the distance of
indicators are ﬂashing.	only half the distance of	Set the FM mode to Mono. See
	regular transmissions?	Set the FM mode to Mono. See
		page 46.
	The AC power cord has not	The AC power cord must be plugged
	The AC power cord has not	into a wall outlet a few times each
The radio presets no longer	been connected to a wall	into a wall outlet a few times each
The radio presets no longer	been connected to a wall	month in order to preserve the radio
work.	outlet for an extended	month in order to preserve the radio
work.	outlet for an extended	presets and other settings.
	period?	presets and other settings.
	period?	Reprogram the presets. See page 42.
		Reprogram the presets. See page 42.

	The tuned station does not	Tune into an FM station that
	support RDS?	supports RDS.

		Install an outdoor FM antenna. See
		page 24.

RDS doesn’t work.

	The signal is too weak?	Try changing the position and
		direction of the outdoor FM
		antenna.

		Locate the FM antenna as far away
	There’s too much	as possible from any ﬂuorescent
	There’s too much	lights. See page 24.
	interference?
	interference?	Install an outdoor FM antenna. See
		Install an outdoor FM antenna. See
		page 24.

	The CR-N1 is exposed to	Place the CR-N1 somewhere free
CD playback skips.	vibration?	from vibration.

	The disc is badly scratched?	Replace with a new disc.
	The disc is badly scratched?	Replace with a new disc.

	The disc is very dirty?	Clean the disc.

	No disc is loaded?	Load a disc. See page 35.
Tracks cannot be memorized
Tracks cannot be memorized	The CD doesn’t contain the	Memorize only available track
with Memory Playback.	track number you are trying	Memorize only available track
	to memorize?	numbers.
	to memorize?

	The disc is loaded the wrong	Load the disc with the labeled side
	way round?	facing forwards. See page 35.
A disc is loaded, but playback
A disc is loaded, but playback	The disc is very dirty?	Clean the disc.
cannot be started.
cannot be started.	Condensation has formed	Unload the disc and leave the CR-N1
		Unload the disc and leave the CR-N1
		for several hours until the
	inside the CR-N1?	for several hours until the
	inside the CR-N1?	condensation has cleared.
		condensation has cleared.

It takes a long time to locate	The disc is very dirty?	Clean the disc.
speciﬁed tracks.	The disc is scratched?	Replace with a new disc.

USB setup has been
completed, but the “new	Windows has become	Restart your PC.
device detected” window	unstable.	Restart your PC.
device detected” window	unstable.
keeps appearing.

Severe electrical interference may render the CR-N1’s microcomputer temporarily inoperable. In this case you should unplug the CR-N1 for at least ﬁve seconds, and then reconnect it.