Remote controller basics

Installing the batteries

1.Open the battery compartment, as shown.

2.Insert the batteries (AA, R6, UM-3) as shown, observing the correct polarity (positive + and negative -).

3.Close the battery compartment, as shown.

Always replace both batteries at the same time. Never mix new and old batteries or batteries of a different type.

If you do not intend to use the remote controller for an extended period, remove the batteries to prevent possible leakage and corrosion.

Remove dead batteries immediately to prevent possible leakage and corrosion.

If the remote controller doesn’t operate reli- ably, replace both batteries.

The bundled batteries should last about six months, although this varies with usage.

Using the remote controller

Remote control sensor

About 5 m

(16 feet)

For reliable operation, point the remote controller toward the CR-N1’s remote control sensor, as shown.

Situate the CR-N1 away from strong light sources, such as direct sunlight or inverter-type florescent lights, which can affect remote controller performance.

Using another remote controller of the same type in the same room, or using the CR-N1 near equipment that uses infrared light may affect remote controller performance.

Do not put items on top of the remote controller that may inadvertently press the remote controller’s buttons, thereby draining the batteries.

The remote controller will not work properly if there’s an obstacle between it and the CR-N1’s remote control sensor.

8