Using the 75/300 ohm FM antenna adapter
(The 75/300 ohm antenna adapter is not included with the U.S., Canadian, and Euro- pean models.)
The 75/300 ohm antenna adapter can be used to connect an FM antenna with 300 ohm flat
Connecting 300 ohm flat twin-core cable
1.Undo the two adapter screws, wrap the bare wires around the screws, and then retighten the screws, as shown.
OutdoorIndoor
antennaantenna
300 ohm flat
Getting connected
Connecting 75 ohm coaxial cable
1.Using a small screwdriver or your fingernails, push the tabs outwards and remove the adapter’s cover, as shown.
2.Move the wire inside the adapter from position A to position B, as shown.
Position A
Wire
Position B
3.Prepare the end of the 75 ohm coaxial cable and place it in the adapter, as shown.
✦ | ✦ | ✦ | ✦ |
|
|
| ||
✦✦ | ✦ ✦ |
|
|
|
|
|
| |
| ✦ ✦ | ✦ |
|
|
|
|
| |
|
| 6 |
| 3 |
|
| 6 | 1 |
| mm |
| mm |
| mm | |||
15 mm
2
4.Push the center conductor between the lugs as shown (1), and use a pair of pliers to clamp the braided wire section of the cable to the adapter (2).
Make sure that the braided wires are not
shorting to the center conductor.
25