Onkyo DR-S2.2 Connecting to a TV or projector, Before connecting, Audio/video connection cable

Connecting to a TV (Other than European model)

Before connecting

•Refer also to the instruction manual of the TV.

•When you connect the DVD Receiver to the TV, be sure to turn off the power and unplug both the units from the mains before making any connections.

•Connect the DVD Receiver to the TV directly. If you connect the DVD Receiver to a VCR, TV/VCR combination, or video selector, the playback picture may be distorted as DVD videos are copy protected.

•Connect the plugs securely.

•Note that one audio/video connection cable and one S video connection cable are supplied.

Incomplete

Insert completely

■Connecting to a TV (or projector)

Using the supplied audio/video connection cable, make audio connections from the TV/LINE IN L and R jacks to the corresponding audio output jacks on the TV. In the same manner, make video connections from the VIDEO MON OUT jack to the corresponding video input jack on the TV.

If your TV has a S video input jack and/or component video input jacks, make S video connection to the S VIDEO MON OUT jack using supplied S video connection cable and/or make component video connection to the COMPONENT VIDEO OUTPUT jacks using component video connection cable (not supplied). These connections allow you to enjoy higher quality picture playback. Be sure not to disconnect

VIDEO MON OUT.

TV or projector

AUDIO		VIDEO S VIDEO		COMPONENT
	OUT	IN	IN		VIDEO IN
R	L			Y	PB PR

Note

The signal that comes in from S VIDEO IN is sent to S VIDEO OUT. The signal that comes in from VIDEO IN is sent to VIDEO OUT.

Notes

•Actual labels for component video inputs may vary depending on the TV manufacturer (ex. Y/CB/CR, Y/B-Y/R-Y, etc.).

•In some TVs, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV for optimum performance.

Be sure to set the digital output setting after connection using the Setup Navigator explained in “Setting Up the DVD Receiver” starting on page 27 or the function setting menu explained in “Customizing the Function Settings” starting on page 64.

Video (Yellow)

L (White)

Audio/video connection cable

R (Red)

Y

PB

Component video connection cable

PR

S video connection cable

Signal flow

ANTENNA	MON
	OUT
	VIDEO
AM
	SUB
	WOOFER
	PRE OUT
FM	AUDIO
75

				REMOTE
	2 ––VIDEO –– 1		MON	CONTROL		DIGITAL
				VIDEO 2		VIDEO 1 OUTPUT
OUT	IN	IN	OUT	OUT	IN	IN
						OPT
						S VIDEO
OUT	IN	IN	OUT	IN	IN
						L
						AUDIO
						R
VIDEO2		VIDEO 1	TAPE		TV/LINE
CDR/PC			MD/HD

DIGITAL INPUT

VIDEO 2	VIDEO 1
OPT	COAX

FRONT SPEAKERS

RL

CENTER

SPEAKER

COMPONENT VIDEO OUTPUT

Y PBPR

SURROUND

SPEAKERS

R	L
	DO NOT connect the
	power cord (mains lead)
	at this time.

See “Turning the unit on/off with the TV’s power switch — IPM function” on page 22 for Inteligent Power Management (IPM) function.

16