Onkyo DR-S2.2 Connecting to a TV European model, Connecting to a TV Using the Scart Cable

Connecting to a TV (European model)

Before connecting

•Refer also to the instruction manual of the TV.

•When you connect the DVD Receiver to the TV, be sure to turn off the power and unplug both the units from the mains before making any connections.

•Connect the DVD Receiver to the TV directly. If you connect the DVD Receiver to a VCR, TV/VCR combination, or video selector, the playback picture may be distorted as DVD videos are copy protected.

•Connect the plugs securely.

Incomplete

Insert completely

■Connecting to a TV Using the SCART Cable

Connect the DVD Receiver and your TV using the supplied SCART cable.

If the TV is compatible with S video signals

After completing the steps on page 26, set “Video Out” to “S Video” using the menu explained in “Customizing the Function Settings” starting from page 64. See page 67 for direct information.

If an RGB monitor is connected to the DVD Receiver

After completing the steps on page 26, set “Video Out” to “RGB” using the menu explained in “Customizing the Function Settings” starting from page 64. See page 67 for direct information.

Be sure to set the digital output setting after connection using the Setup Navigator explained in “Setting Up the DVD Receiver” starting on page 27 or the function setting menu explained in “Customizing the Function Settings” starting on page 64.

TV or projector

AC

CONNECTOR

SCART cable

To AC CONNECTOR input terminal

ANTENNA	MON
	OUT
	VIDEO
AM
	SUB
	WOOFER
	PRE OUT
FM	AUDIO
75

				REMOTE
	2 ––VIDEO –– 1		MON	CONTROL		DIGITAL
				VIDEO 2		VIDEO 1 OUTPUT
OUT	IN	IN	OUT	OUT	IN	IN
						OPT
						S VIDEO
OUT	IN	IN	OUT	IN	IN
						L
						AUDIO
						R
VIDEO2		VIDEO 1	TAPE		TV/LINE
CDR/PC			MD/HD

DIGITAL INPUT			AV CONNECTOR
VIDEO 2	VIDEO 1
OPT	COAX
FRONT SPEAKERS		CENTER	SURROUND
R	L	SPEAKER
			SPEAKERS

R L

DO NOT connect the power cord (mains lead) at this time.

	See “Turning the unit on/off with the TV’s power
	switch — IPM function” on page 22 for Inteligent
Video	Power Management (IPM) function.
(Yellow)	R
	AUDIO
	OUT
L (White)	L

	Audio/video	VIDEO	TV or projector
R (Red)	connection cable	IN
		S VIDEO
		IN

S video connection cable

Signal flow

■Connecting to a TV usinf the Audio/Video connection cable or S video connection cable

If the TV or monitor does not has an AV CONNECTOR input terminal, make video connection using audio/video connection cable.

If your TV has an S video input jack, make the S video connection. The S video connection will provide higher quality picture playback. Be sure not to disconnect VIDEO MON OUT.

17