Onkyo DR-S2.2 Listening to the Radio, Tuning Manually, Presetting Radio Stations

Listening to the Radio

There are two ways to select radio stations:

•Manual tuning

•Presetting radio stations then selecting the preset channels

Tuning Manually

1	Unit	Press INPUT 5/∞ repeatedly to
		select the band (FM or AM).
		e.g. When FM is selected.
		Note
		You can also select the band with the remote
		controller. See next page.
2	Unit only	Press and hold TUNING/PRESET
		4/¢ for about 0.5 seconds.

Appears when a broadcast is received.

•When the band is FM

Auto tuning starts. The frequency changes in 50 kHz steps.

When a broadcast is received, scanning stops and the frequency flashes in the display.

•When the band is AM

The frequency changes as follows:

–(North American and South American models)

In 10 kHz steps

–(Other models)

	In 9 kHz steps
	When you release the button, the frequency
	stops changing and flashes in the display.
3	While the frequency is flashing (for
	about 5 seconds), press TUNING/

PRESET 4/¢ to change the frequency.

•The frequency changes each time you press TUNING/PRESET 4/¢.

•You can change the frequency as long as the frequency in the display is flashing. Each press of either button causes the frequency to flash for about 5 seconds.

FM MODE

INPUT 5/∞ PRESET MEMORY

TUNING/PRESET 4/¢

Tuning in a weak frequency (only for FM stations)

When you tune in a stereo FM station, the FM ST indicator lights up if the signal is sufficiently strong.

If the signal is weak, you may not be able to tune to the station.

In this case, press FM MODE. The FM ST indicator and AUTO goes off. Then select the station to which you want to listen.

(At this time, the station will be in mono and interstation noise will be heard.)

Unit Only

Presetting Radio Stations

You can preset up to 30 stations.

1		Tune in the radio station you wish
		to preset (see steps in the left
		column of this page).
2	Unit only	Press PRESET MEMORY.
		The MEMORY indicator lights and the

preset number starts flashing in the display.

3	While the MEMORY indicator is lit
	(for about 8 seconds), press

TUNING/PRESET 4/¢ to select the preset number.

4	Press PRESET MEMORY.
	The radio station is registered to the

preset channel.

To register another preset station, repeat steps 1 to 4.

38