Onkyo DR-S2.2 Place the remote controller, Remote controller for the other, Inches apart, Buttons

5 to 15 cm

(2 to 6 inches)

SEND/LEARN

indicator

MODE

buttons

ENTER

: Buttons that cannot be programmed.

Programming the commands of remote controllers for other devices into the remote controller

When programming the commands of another remote controller to the RC-484M remote controller, you must first decide under which MODE button you want the commands to be linked. In general, you will select the MODE button that corresponds to the component you are programming.

After programming which MODE button to use, you will then transfer the separate commands from the other remote controller over to the RC-484M remote controller one at a time. Each command is then programmed to a different button on the RC-484M remote controller. Any button is programmable for this step except for the six MODE buttons (DVD, CDR, TAPE/MD/HD, AUDIO, VCR, TV).

Even after the commands have been memorized, keep your old remote controller in a safe place. If for some reason the commands are lost (e.g., when the batteries run down), it will be necessary to memorize them once again.

1	Place the remote controller and the
	remote controller for the other
	device facing each other at a
	distance of 5 to 15 cm (2 to 6
	inches) apart.
2	While pressing and holding down
	the desired MODE button on the
	remote controller, press the ENTER
	button and then release both
	buttons.
	When you press and hold down the MODE
	button, the SEND/LEARN indicator lights.
	When you press the ENTER button, the
	lamp turns off. When you release the
	buttons, the lamp lights again.
3	Press and release the button on the
	remote controller to which you want

to transfer the next command.

You may select any button but the eight ones indicated in the figure below. When you press the button, the SEND/LEARN indicator turns off. When you release the button, the indicator lights again.

If you press the wrong button by mistake, press that same button again. The SEND/ LEARN indicator flashes twice, and the remote controller exits the programming mode.

81