Onkyo DR-S2.2 instruction manual Speaker Setup

The normal display resumes in three seconds.

Speaker configuration indicator at the upper left corner shows the current speaker configuration.

(Front left, center, and right, plus surround left and right

speakers)

↓

Speaker 2ch

(Front left and right speakers)

↓

SP SETUP

Before operating the remote controller Press MODE AUDIO.

The remote controller remains in the AUDIO mode, until another MODE button is pressed.

Speaker Setup

(North American and South American model)

You need to set up the speaker configuration for the speaker system connected to the FRONT SPEAKERS A connectors (see this page.) (There is no speaker configuration setup for the FRONT SPEAKERS B system.)

(Other then North American and South American models)

You need to set up the speaker configuration for the speaker system connected to the SPEAKERS connectors (see page 30.)

Notes

•Speaker setup cannot be done if;

–Headphones are connected (see page 43), or

–The FRONT SPEAKERS B system is On (North American and South American model only, see page 42).

•It is not necessary to set the parameters again once you have completed the setup unless you change the speaker configuration.

Selecting the number of speaker channels (North American and South American model)

See following page for other than North American and South

American model.

SPEAKER A/B

1	Unit only	Press SPEAKER A/B to select	Pressing the button repeatedly within three
			seconds changes the number of channels
	SPEAKER	“Speaker A.”	as follows (the corresponding speaker
	A / B
			configuration is described in parentheses):
				→	Speaker 5ch

Note

“Speaker B” also appears by pressing the button repeatedly, though, this setting is reserved for future applications. Therefore, be sure to select “Speaker A.”

2	Press SP SETUP repeatedly to	Speaker 3ch
		(Front left, center, and right
	select the number of channels for
Remote controller		speakers)
	the SPEAKERS A system.
only		↓
	Speaker configuration indicators indicate	Speaker 4ch
	current speaker configuration.	(Front left and right, plus
		surround left and right speakers)

Notes

• The listening mode will automatically be set to “Stereo” (see page 48) once you set or reset the number of channels.

• To check the present setting while the normal display is displayed, press SPEAKER SETUP once. To change the setting,

press the button repeatedly within three seconds. 29