Programming the commands of remote controllers for other devices into the remote controller
SEND/LEARN indicator
MODE buttons
ENTER
Erasing the programmed command from one button
You can only erase memorized commands and not preset ones.
1.Press and hold down the desired MODE button for the command, press the ENTER button, and then release both buttons.
When you press the MODE button, the SEND/LEARN indicator lights. When you press the ENTER button, the lamp turns off. When you release the buttons, the lamp lights again.
2.Press and release the button for the command you wish to erase.
When you press the button, the SEND/LEARN indicator turns off. When you release the button, the lamp lights again.
3.Press and release the same button again.
The SEND/LEARN lamp flashes twice slowly. The memorized command is erased.
Note:
If no button is pressed for more than 30 seconds during the erasing procedure, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the erasing mode. Resume from Step 1.
SEND/LEARN indicator
MODE 
buttons
ENTER
Erasing all the commands programmed under a MODE button
1.Press and hold down the desired MODE button, press the ENTER button twice, and then release both buttons.
When you press the MODE button, the SEND/LEARN indicator lights. When you press the ENTER button, the lamp turns off. When you release the buttons, the lamp flashes twice slowly and then lights again.
2.Press and release the same MODE button again.
When you release the button, the SEND/LEARN indicator flashes twice slowly. This erases all the commands memorized to the MODE button.
Notes:
•If no button is pressed for more than 30 seconds during the erasing procedure, the SEND/LEARN indicator flashes three times quickly and the remote controller exits the erasing mode. Resume from Step 1.
•If you perform an invalid operation during erasing, the SEND/ LEARN indicator flashes three times quickly, and the remote controller exits the erasing mode. Resume from Step 1.
•If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for up to 20 seconds during Step 2. This is not a malfunction.
65
