Onkyo TX-DS898 Switching the display, Adjusting the brightness of the front display

Remote controller

Enjoying music or videos with the TX-DS898

Input source buttons

MASTER VOLUME

STANDBY/ON

STANDBY

POWER

ONOFF

SLEEP

RCVR

CH SEL TEST

ZONE 2 (GRN )

AUDIO

REC ( RED )

DVD

VIDEO 1

VIDEO 2

VIDEO 3

VIDEO 4

VIDEO 5

TAPE

FM

AM

PHONO

C D

PURE AUDIO UPSAMPLING

SELECTOR

DISPLAY

PHONES

REC OUT

ZONE 2

OFF

STEREO

SURROUND

THX

DSP

DIMMER FM MODE

MEMORY SETUP

ENTER

RETURN

VIDEO 5/VIDEO CAM INPUT

ZONE 2 LEVEL

CLEAR

TUNING

PRESET

S VIDEO

VIDEO

L AUDIO R

DIGITAL

DISPLAY

LEVEL /

DIMMER

DISPLAY DIMMER

Switching the display

While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the DISPLAY button on the TX-DS898 or the remote controller.

TX-DS898	Remote controller
DISPLAY

When an input source other than FM or AM is selected:

Input + volume

Program format*

Input + Listening mode or Multi Ch

*If the input signal does not have a program format, then this will be skipped.

When FM or AM is selected as the input source:

FM/AM frequency +	ch
Preset no.

FM/AM +

Listening mode

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the TX-DS898 with DIMMER button on the remote controller or on the TX-DS898 front panel.

TX-DS898	Remote controller
DIMMER

Using the sleep time (remote controller only)

The SLEEP button enables you to set the TX-DS898 to turn off automatically after a specified time period. If you press it once, the TX-DS898 will turn off after 90 minutes. Each time it is pressed thereafter, the remaining time until the TX-DS898 turns off decreases by 10 minutes. While, the sleep function is enabled, you can press the SLEEP button to see how much time is left. To cancel the sleep function, press the SLEEP button when the time displayed is less than 10 minutes.

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with main zone turned on and then put the main zone into the standby state.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 to +12 decibels. Note that the calibration settings will return to the original settings when the TX-DS898 is put in standby.

1. Press the RCVR MODE button.

2. Press the CH SEL button and select the desired speaker.

3. Press the LEVEL or button to adjust the volume level.

Notes:

•You cannot select a speaker if the Speaker Config sub-menu of the Speaker Setup is set to No or None.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

•When you press the TEST button after you set the level, the current level will be used as the value set via the test tone.

50