Onkyo TXNR727 instruction manual En-15, Connecting the TV/AV components

Connecting the TV/AV components

Before connecting the power cord, connect all of your speakers and AV components. To display the setup menu on the TV screen, connecting the TV to HDMI OUT MAIN is required.

F J G H I E D C B A

Connections

DUse this jack to connect to the set top box/digital video recorder, etc.

EUse this jack to connect to the game consoles, etc.

GUse this port to connect to a LAN port on a router so the AV receiver can be connected to your home network.

HUse jack and terminal here to connect the supplied FM antenna and AM loop antenna.

IUse this jack to make connections using an analog audio cable.

With this connection, you can also enjoy analog audio from external components while you are in Zone 2/3.

JUse this jack to make connections using a component video cable.

KUse this jack to connect to the camcorder/MHL- enabled mobile device, etc.

If you select the input selector button, the signal from the component connected to the assigned jack is played.

B C D E	K	Input selector
		buttons

•Before making any AV connections, read the manuals supplied with your AV components.

•Push plugs in all the way to make good connections (loose connections can cause noise or malfunctions).

•To prevent interference, keep audio and video cables away from power cords and speaker cables.

Connections

AUse this jack to connect to the HDMI input of the TV. If your TV doesn’t support Audio Return Channel (ARC)*1, you need to connect an optical digital cable together with the HDMI cable to jack

F.

Another TV can be connected to the HDMI OUT SUB jack.

*1 ARC is the function that carries the audio signal from the TV to jack A. With ARC, a single HDMI cable can connect the TV and the AV receiver.

BUse this jack to connect to your Blu-ray Disc/DVD player, etc.

CUse this jack to connect to the Satellite/cable set- top box, etc.

Tip

•To listen to the audio of a component connected via HDMI through your TV’s speakers, enable “HDMI Through” (➔ page 70) and set the AV receiver to standby mode.

•In the case of Blu-ray Disc/DVD players, if no sound is output despite following the above-mentioned procedure, set your Blu-ray Disc/DVD player’s HDMI audio settings to PCM.

•Connect a turntable (MM) that has a built-in phono preamp to TV/CD IN, or connect it to PHONO IN with the phono preamp turned off. If your turntable (MM) doesn’t have a phono preamp, connect it to PHONO IN. If your turntable has a moving coil (MC) type cartridge, you’ll need a commercially available MC head amp or MC transformer to connect to PHONO IN. See your turntable’s manual for details.

If your turntable has a ground wire, connect it to the AV receiver’s GND screw. With some turntables, connecting the ground wire may produce an audible hum. If this happens, disconnect it.

En-15