Onkyo TXNR727 En-27, Performing Wireless LAN Setup, Automatic wireless LAN setup

Performing Wireless LAN Setup

A wireless LAN (WLAN) is a local area network that relies on wireless communication.

To achieve a wireless network connection, you will need the following component:

■Access point

Also known as the base station, it links your AV receiver (wireless client) with a PC or network. Access points fall into two categories: the bridge type that only performs data relay in a local area network, or the router type that has a built-in router functionality.

To achieve a wireless network connection, it is necessary to perform the wireless LAN setup. The setup can be done either automatically or manually. You use your AV receiver as a wireless client (wireless terminal) and connect it to a PC or to the Internet.

		Turning On & Basic Operations
5 Use q/wto select “Network Connection”, and		■ PIN code method
		1. Use q/wto select “PIN Code” and then press
	e/rto select “Wireless”, and then press
	ENTER (➔ page 72).	ENTER.
	The “Wireless Setup” menu is displayed on	An 8-digit PIN code is displayed. The PIN
	screen.	code is displayed scrolling on the AV
		receiver’s display.
	Tip
		2. Input the provided code in your Access Point.
	• The same setting is available even if “Wireless” is
		For information on the registration process,
	selected in “Network Connection” in initial setup
		please refer to the instruction manual
	(➔ page 23).
6 Press q/wto select (North American models)		provided with your Access Point device.
		7 Press ENTER to confirm.
	“Push Button Configuration (Other
	Routers)”*1/(excluding North American	Connection to your Access Point starts and Wi-Fi
	models) “Push Button Configuration (Select	indicator flashes. After the connection to your
	from Router)”, and press ENTER.	Access Point is completed, Wi-Fiindicator lights
	The method to make settings by “Push Button	and the connection status is displayed on the
	Configuration” is displayed, providing the	screen.
	following two options:	This completes the wireless LAN setup.
		You can review your setup with the “Status”
	Tip
		option on the “Wireless Setup” menu.
	*1 (North American models) To connect to Linksys

Automatic wireless LAN setup

1	Press RECEIVER followed by HOME.
2	Use e/ror q/wto select “Setup”, and then
	press ENTER.
3	Use q/wto select “Hardware Setup”, and then

E/EA Router, select “Push Button Configuration (Linksys E/EA Router)” and make settings

following the instructions on the screen.

■Push Button method

1.Use q/wto select “Push Button” and then press ENTER.

2.Press the WPS button on your Access Point device.

Note

•If Wi-Fiindicator doesn’t light, the connection to your Access Point is not done successfully. Configure this setting again (➔ page 85).

press ENTER.

4 Use q/wto select “Network”, and then press

ENTER.

Tip

•How long the WPS button should be pressed differs depending on the type of Access Point device. Refer to the instruction manual provided with your Access Point device for operations.

En-27